Fumoto USA Sales
2023-08-01 17:55:05

Installation guide for standard valves

Standard valves

 


1. Prepare: 

  • Assemble: Place the blue fiber gasket (not required for tapered thread or O-ring valves) onto the valve so it will sit flat between the oil pan and the valve once installed.
  • Prepare: Remove drain plug from oil pan. Drain old oil. Clean drain port area before installation. 

2. Install:

  • Hand tighten: Thread the valve into the oil drain port by hand, do not cross-thread.
  • Fully Tighten: Tighten with a crescent wrench on the body of the valve*  ⅛ to ¼ turn past hand tight, or to the value shown on the torque chart for your valve model. Do not over tighten. 
    • Do not use a wrench on the head of the nipple outlet if present.
    • An adapter may be required if the valve cannot be completely tightened due to contact with the oil pan. 

3. Close and Fill up:

  • Close the the valve by firmly turning the control lever clockwise until it stops and is perpendicular to the oil outlet. The lever will click into the recess and lock in position. 
  • Install a lever clip (optional) and refill with new oil.

 

OPERATION

 

  • To open the valve, remove the lever clip if installed then lift the lever and turn it.
  • To close the valve, For Standard valves turn the lever firmly until it stops and is perpendicular to the oil outlet. For SX type valves turn the lever firmly until it stops and is parallel to the oil outlet. The lever will click into the recess and lock in position. You should not be able to rotate the lever without first lifting upward. Reinstall the lever clip around the turret of the valve. If the lever is not seated properly, the lever clip will not fit. 

 

Warning: 

  • Check the oil pan for leaks before operating your vehicle.
  • Drive carefully at all times, and if you run over any foreign object on the road pull over and inspect the valve for any damage or leak.
1 out of 1 found this helpful.

Related Articles

Articles In This Folder